User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
If a unit requires more complete testing or service than is customarily performed at the basic
level, send the repeater or FRU to a Motorola Solutions Service Center.
The following disassembly procedures should be performed only if necessary.
11.5.2
Disassembly – Detailed
11.5.2.1
Protective Cover Disassembly
Procedure:
1 Remove the six screws on the Bottom Cover with a T10 Torx driver.
2 Detach the Bottom Cover.
3 Remove the six screws on the Top Cover with a T10 Torx driver.
4 Detach the Top Cover.
11.5.2.2
Front Housing Disassembly
Procedure:
1 Remove the three screws securing the Front Housing to the repeater chassis with a T10 Torx
driver.
2 Slightly lift the Repeater and rock the Front Housing away from the chassis.
Figure 49: Removing Front Housing from Repeater
11.5.2.3
Cable Disassembly
Prerequisites:
NOTICE: When disengaging flexible cables, pull parallel to the insertion direction of the cable to
avoid damaging the cables.
Procedure:
1 Disengage cable connecting Modem to Chassis ID module.
MN001436A01-AD
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
100 Send Feedback