User's Manual

Figure 99: CPS Configuration for Trident Model Raider, Marauder and NTS
Trunking Controller Settings
The input and output levels should be adjusted per the trunking controller’s instructions. The summary
below gives a brief overview of the high level characteristics and trunking controller settings for
configuration with the SLR 5000 Series Repeater.
Discriminator
The Receiver audio yields 330 mV rms into 50 kΩ with an RF input signal deviating at 60% RSD. With
the trunking controllers own loading impedance, the “Discriminator” signal delivered to the trunking
controller requires a boost by setting the following jumpers in the noted position:
• Marauder and Raider
- W22: OUT position
- W30: IN position
Tx Audio
The transmitter yields 60% RSD with 80 mV rms into the Emph Tx Audio port. No range setting is
provided in the trunking controller for the Tx Audio, rather the level is solely controlled by a singular
potentiometer or soft-potentiometer.
Tx Data
transmitter yields 60% RSD with 80 mV rms into the Tx Data port. No range setting is provided in the
trunking controller for the Tx Data, rather the level is solely controlled by a singular potentiometer or
soft-potentiometer.
• Marauder, Raider and NTS
- Data needs to be inverted
- NTS needs to be set for DSP operation (Channel card setting)
MN001436A01-AD
Appendix D: SLR 5000 Series Third-Party Controllers
154 Send Feedback