User's Manual

Figure 96: Model Trident’s Raider
Figure 97: Model Trident’s NTS
Compatibility
Trident Model Raider, Marauder and NTS are compatible for all versions of SLR 5000 Series Repeater
software and hardware.
Hardware Connections
The connections between the SLR 5000 Series Repeater and the trunking controllers are facilitated
with a multi-conductor cable connected between the J7 SLR 5000 Series back panel AUX 25-Pin
connector and that of the connector on the trunking controller. The connection provides for the
following signals:
• Transmit Audio
• Transmit Data
• Receiver Audio
• PTT
• 13.6 VDC (see Note)
• Ground
NOTICE: If this connection is used, the external equipment must draw less than 1 A. This
connection is not supported for the NTS controller.
Signal connections are noted in Figure 86: CPS Configuration for Community Repeater Panel (1 of 2)
on page 143. The SLR 5000 Series Repeater connector and physical Pin locations are noted in the
backplane interface board section of this manual. See the Trident manuals for their respective
MN001436A01-AD
Appendix D: SLR 5000 Series Third-Party Controllers
152 Send Feedback