User's Manual
Table Of Contents
- SLR 5000 Series Installation
- 12.1 Pre-Installation Considerations
- 12.2 Mechanical Installation
- 12.3 Electrical Connections
- 12.4 Post Installation Checklist
- 12.5 Installing Repeater Hardware Options
- Appendix A: Accessories
- Appendix B: Replacement Parts Ordering
- Appendix C: Motorola Solutions Service Centers
- Appendix D: SLR 5000 Series Third-Party Controllers
- Appendix F: MOTOTRBO Repeater – EME ASSESSMENT
- Glossary of Terms and Acronyms
- Alert tone
- Analog
- ASIC
- AUX
- Band
- CTCSS
- Clear
- Conventional
- CPS
- Default
- Digital
- DPL
- DSP
- EIA
- ESD
- EU
- FCC
- FM
- Frequency
- FRU
- FSK
- GNSS
- GPIO
- IC
- IF
- I/O
- kHz
- LCD
- LED
- MDC
- MHz
- MISO
- MOSI
- PA
- PC Board
- PFC
- PL
- Programming Cable
- PTT
- Receiver
- Repeater
- RF
- RSSI
- Rx
- SCM
- SELV
- Signal
- SINAD
- SLR
- Spectrum
- SPI
- Squelch
- TOT
- TPL
- Transceiver
- Transmitter
- Trunking
- Tx
- UHF
- USB
- VCO
- VCTCXO
- VHF
- VIP
- VSWR
- WLAN
- Active Low
• GPIO Pin number 4
- CSQ Detect or PL/ Talk group Detect
- Active Low
• GPIO Pin number 24
- Monitor
- Active Low
• GPIO Pin number 8, 25
- Channel Select 1
- Active Low
• GPIO Pin number 10, 12
- Channel Select 2
- Active Low
• GPIO Pin number 15
- Channel Select 3
- Active Low
• GPIO Pin number 21
- Channel Select 4
- Active Low
Figure 94: CPS Configuration for L3276 Tone Remote Adapter
(For a 15 Channel Remote Control)
NOTICE: The above configuration is considered typical. The L3276 Remote Tone Adapter
provides alternate configurations that are supported by SLR 5000 Series Repeater as well. See
L3276 Remote Tone Adapter Manual for additional details.
MN001436A01-AD
Appendix D: SLR 5000 Series Third-Party Controllers
150 Send Feedback