User's Manual

Signal connections are noted in Figure 1. The SLR 5000 Series Repeater connector and physical Pin
locations are noted in the backplane interface board section of this manual. See Zetron Model 30
manual for its connector and physical Pin locations. The part number for a pre-fabricated cable is noted
in the SLR 5000 Series ordering guide.
Figure 89: Signal Connections between SLR 5000 Series Repeater and Zetron Model 30 Phone
Patch (Analog Phone Patch Cable & Digital Phone Patch Cable)
White
Black (Paired with White)
Shield from Blk/White Pair
Green
Black (Paired with Green)
Shield from Blk/Green Pair
Red
Black (Paired with Red)
Shield from Blk/Red Pair
Model 30
Molex 1x 10 Connector
Tx Audio
PTT
Gnd
Discriminator
COR Input
Gnd
12VDC+
Gnd
SLR 5000 Series
Male DB25
Tx Audio
GPI 1 (PTT)
Gnd
Rx Audio
Gnd
13.6 VDC
Gnd
5
7
4
3
8
6
1
2
1
2
16
7
4
17
20
19
18
CPS Configuration
The SLR 5000 Series Repeater will need to be configured via the CPS application as shown in Figure
86: CPS Configuration for Community Repeater Panel (1 of 2) on page 143 and Figure 87: CPS
Configuration for Community Repeater Panel (2 of 2) on page 144. More specifically, the affected
parameters are as follows:
• Audio Type
- Filtered Squelch
• Analog Accessory Emphasis
- De & Pre
• Disable Repeat Path
- Un-Checked
• Tx Audio Priority
- 0
• GPIO Pin number 2, 11
- Ext PTT
- Active Low
• GPIO Pin number 4
- PL/Talkgroup Detect
- Active Low
• Squelch Type (Rx)
- TPL
• Squelch Type (Tx)
- TPL
MN001436A01-AD
Appendix D: SLR 5000 Series Third-Party Controllers
146 Send Feedback