User's Manual

Figure 87: CPS Configuration for Community Repeater Panel (2 of 2)
Community Repeater Panel Settings
The input and output levels should be adjusted per the community repeater panel’s instructions. The
following sections give a brief overview of the high level characteristics and community repeater panel
settings for configuration with the SLR 5000 Series Repeater.
Discriminator
The Receiver audio yields 330mV rms into 50 kΩ with an RF input signal deviating at 60% RSD. With
the community repeater panel’s own loading impedance, the “Discriminator” signal delivered to the
community repeater panel is at a high enough drive level to leave the community repeater panel’s “Rx
Audio Gain High/Low” switch in the factory default position (back panel Switch 1).
NOTICE: Under the System Programming, turn on the DCS Rx data.
Tx Audio
The transmitter yields 60% RSD with 80 mV rms into the Emph Tx Audio port. The "Tx Audio" signal
delivered by the community repeater panel is at a high enough drive level to leave the community
repeater panel's "Tx Audio Gain High/Low" switch in the factory default position (back panel Switch 4).
NOTICE: Under the System Programming, turn on the DCS Tx data.
Continuous Tone-Controlled Squelch Systems (CTCSS) Out
The transmitter yields 60% RSD with 80 mV rms into the Tx Data port.
The "CTCSS" signal delivered by the community repeater panel is at a high enough drive level to leave
the community repeater panel's "Encode gain high/low" switch in the factory default position (back
panel Switch 3).
MN001436A01-AD
Appendix D: SLR 5000 Series Third-Party Controllers
144 Send Feedback