User's Manual

11.6.1.3
Power Amplifier Module Installation
Procedure:
1 Insert the TX connector into the back panel.
2 Slide the Power Amplifier Module into the repeater chassis until it rests against the back panel.
Figure 63: Installing Power Amplifier Module into Repeater
3 Lightly torque the four M4 x 0.7 x 10 mm screws (PN: 0310909A61) shown in Figure 64:
Securing Power Amplifier Module to Repeater Chassis on page 108 with a T20 Torx driver so
the screws are very lightly installed. Do not tighten down beyond initial seating.
4 Assemble the lock washer (PN: 04009303001) and 0.75 in. (19 mm) hex nut (PN: 02009277001)
onto the TX connector of the Power Amplifier Module. Tighten the nut to 20 in-lb (2.3 N-m) with
a 0.75 in. (19 mm) hex nut driver.
5 Tighten the four M4 x 0.7 x 10 mm screws (PN: 0310909A61) to 15 in-lb (1.7 N-m) with a T20
Torx driver to secure the Power Amplifier Module to the repeater chassis.
Figure 64: Securing Power Amplifier Module to Repeater Chassis
11.6.1.4
Modem Installation
Procedure:
1 Lift the RX and Reference (REF) cables and slide the Modem all the way to the back panel.
Make sure the mounting ears on the Modem line up with the screw holes on the repeater
chassis.
MN001436A01-AD
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
108 Send Feedback