User's Manual

• Go off for one second, then
• Indicate the operational status of the repeater.
12.4.4
Repeater Codeplug Data Backup
Backup the repeater codeplug data by using the Customer Programming Software (CPS) on a
computer.
12.5
Installing Repeater Hardware Options
This section describes ways to install the hardware options of the repeater.
12.5.1
General Bonding and Grounding Requirements
Cabinets and racks used to mount the repeater and optional equipment include a rack grounding bar
with the capacity to terminate numerous ground wires. Equipment added to the cabinet or rack should
be attached to the grounding bar using solid or stranded 6 AWG copper wires. See the Motorola
Solutions R56 manual Standards and Guidelines for Communication Sites (which can be obtained by
ordering CDROM 9880384V83) for more information on proper bonding and grounding at a site.
12.5.2
General Cabling Requirements
Diagrams for cabling are typically included in the system–specific configuration documentation
provided by Motorola Solutions. Also see the Motorola Solutions R56 manual Standards and
Guidelines for Communication Sites (which can be obtained by ordering CDROM 9880384V83) for
cabling standards.
MN001436A01-AD
Chapter 12: SLR 5000 Series Installation
132 Send Feedback