User's Manual

• grounding.
Figure Figure 81: Back Panel Connector Names and Locations on page 129 shows the position of the
repeaters external connectors located on the back panel of the repeater. Table 42: Connector Type
and Primary Function on page 129 identifies the connector types as well as a given connector's
primary function.
Figure 81: Back Panel Connector Names and Locations
1
2
3
4
5
6
8
7 11
9
10
12
Table 42: Connector Type and Primary Function
Location Connector Type Function(s)
1 C14 (IEC 60320) AC Power Inlet of Repeater Power Switch
2 Molex 42818-0212 DC Power Inlet and DC Charger Outlet
3 Option Dependent Option Dependent 1
4 Option Dependent Option Dependent 2
5 Type A Socket USB
6 RJ-45 – Jack Ethernet 2
7 RJ-45 – Jack Ethernet 1
8 DB25 – Female Aux: Rx Audio, Tx Audio, PTT, COR, Accessory Power, 1 PPS, and
GPIO
9 BNC – Female Receiver RF (Rx)
10 BNC – Female Frequency Reference Input (REF)
11 T30 TORX Screw Bonding Ground Connection
12 N-Type – Female Transmitter RF (Tx)
There is also a USB connection associated with maintenance and troubleshooting of the repeater. This
connection is located on the front of the repeater. See Figure 82: Location of USB Connector on page
129.
Figure 82: Location of USB Connector
1
MN001436A01-AD
Chapter 12: SLR 5000 Series Installation
Send Feedback 129