User's Manual
Table Of Contents
- SLR 5000 Series Installation
- 12.1 Pre-Installation Considerations
- 12.2 Mechanical Installation
- 12.3 Electrical Connections
- 12.4 Post Installation Checklist
- 12.5 Installing Repeater Hardware Options
- Appendix A: Accessories
- Appendix B: Replacement Parts Ordering
- Appendix C: Motorola Solutions Service Centers
- Appendix D: SLR 5000 Series Third-Party Controllers
- Appendix F: MOTOTRBO Repeater – EME ASSESSMENT
- Glossary of Terms and Acronyms
- Alert tone
- Analog
- ASIC
- AUX
- Band
- CTCSS
- Clear
- Conventional
- CPS
- Default
- Digital
- DPL
- DSP
- EIA
- ESD
- EU
- FCC
- FM
- Frequency
- FRU
- FSK
- GNSS
- GPIO
- IC
- IF
- I/O
- kHz
- LCD
- LED
- MDC
- MHz
- MISO
- MOSI
- PA
- PC Board
- PFC
- PL
- Programming Cable
- PTT
- Receiver
- Repeater
- RF
- RSSI
- Rx
- SCM
- SELV
- Signal
- SINAD
- SLR
- Spectrum
- SPI
- Squelch
- TOT
- TPL
- Transceiver
- Transmitter
- Trunking
- Tx
- UHF
- USB
- VCO
- VCTCXO
- VHF
- VIP
- VSWR
- WLAN
Table 40: Cabinet Slide
Model Description
THN6788 Slides Motorola Solutions Cabinet
CAUTION: Ensure that the cabinet is securely anchored to the floor, thereby avoiding possible
equipment tipping and personal injury.
Figure 78: Floor Mount Cabinet
FRONT VIEW
TOP VIEW
SIDE VIEW
Big holes
(2)
VIEWED FROM
TOP
Small
holes (4)
Station
Support
Brackets (2)
Mounting
Rails (4)
12.1.5.2
Modular Racks
See Table 41: Rack Models on page 123 for the rack models and associated description.
Table 41: Rack Models
Model Description
THN6752 30 in. (76.2 cm) Modular Rack (16 RK U)
THN6753 45 in. (114.3 cm) Modular Rack (24 RK U)
THN6754 52 in. (132.08 cm) Modular Rack (27 RK U)
The side, top and bottom views for all available modular racks are shown in Figure 79: Modular Rack
on page 124. The top and bottom plates are identical and all dimensions and clearances are common
to all racks.
Recommended clearance front and rear is 91.44 cm (36 in.) minimum for servicing access. Refer to
Equipment Ventilation on page 120 for recommended ventilation clearances.
FRU kit PMLN6826 (Rack Mount Hardware) is included with each rack model. This allows proper
installation of the SLR 5000 series repeater within the racks center of gravity.
MN001436A01-AD
Chapter 12: SLR 5000 Series Installation
Send Feedback 123