User's Manual

English
English
4
MOTOTRBO SLR 5000 Series Repeater
Supplemental Safety and Installation
Requirements
ATTENTION!
The MOTOTRBO SLR 5000 Series Repeater must be installed in a
suitable, in-building enclosure. A restricted access location is required
when installing this equipment into the end system.
The repeater contains a Class 1 built-in power supply component. It is
equipped with an appliance inlet for connecting to an AC input, as
well as DC input terminals which meet SELV DC circuit requirements.
When installing the equipment, all requirements of relevant standards
and local electrical codes must be fulfilled.
The maximum operating ambient temperature of this equipment is
60°C. The maximum guaranteed operating altitude is 2000 meters
above sea level. Operating above this maximum altitude may result in
degradation to product specifications and compliances.
The nominal13.6 VDC output from the power supply to the PA is at an
energy hazard level (exceeds 240 VA).
When installing into the end system, care must be taken so as not to
touch the output wires. When the MOTOTRBO SLR 5000 Series
Repeater is used in a DC reverting system, the DC power supply
must be located in the same building as the MOTOTRBO SLR 5000
Series Repeater, and it must meet the requirements of a SELV circuit.
General Installation
Proper installation ensures the best possible performance and
reliability of the repeater equipment. Pre-installation planning is
required. This includes considering the mounting location of the
equipment in relation to input power, antennas, and system
interfaces. Also to be considered are site environment conditions, the
particular mounting method (several available), and the required tools
and equipment.
If this is the first time installing this type of equipment, it is highly
recommended that the user read the following:
• Chapter 12 of the SLR 5000 Series Basic Service and Installation
Manual before beginning the actual installation.
Pre-Installation Overview
The following information is an overview for installing the SLR 5000
Series Repeater:
List of Supplied Items
• SLR 5000 Series Repeater
• Cabinet and Rack mounting hardware
• AC line cord
• Quick Start Guide
NOTE: Save the SLR 5000 Series Repeater shipping container
and its components to facilitate possible future SLR 5000
Series Repeater shipping needs.

SLR_5000_NAG.book Page 4 Monday, March 2, 2015 10:19 AM