User's Guide Part 2

ManualsBrandsMotorola Solutions ManualsElectronicsUHF Portable Radio

Advanced Features

English

If your radio is set to Silent with Voice, it will not display any

audio or visual indicators during Emergency mode, but allow

incoming calls to sound through the radio’s speaker. The

indicators will only appear once you press the PTT button to

initiate, or respond to, the call.

Sending an Emergency Alarm with Voice to

This feature allows you to send an Emergency Alarm to a group

of radios. Your radio’s microphone is automatically activated,

allowing you to communicate with the group of radios without

pressing the PTT button.

This activated microphone state is also known as "hot mic".

If you press the PTT button during the programmed hot mic

transmission period, the radio ignores the PTT press and

remains in Emergency mode.

NOTE: If you press the PTT button during hot mic, and

continue to press it after the hot mic duration expires,

the radio continues to transmit until you release the

PTT button.

Procedure:

1 Press the programmed Emergency On button.

2 The display shows Tx Alarm and the destination alias. The

LED lights up solid green and the Emergency icon appears.

3 Once the display shows Alarm Sent, speak clearly into the

microphone. When hot mic has been enabled, the radio

automatically transmits without a PTT press until the hot mic

duration expires.

4 While transmitting, the LED lights up solid green and the

Emergency icon appears.

5 Once the hot mic duration expires, the radio automatically

stops transmitting. To transmit again, press the PTT button.

6 Press Emergency Off button to exit the Emergency mode.

7 The radio returns to the Home screen.

If your radio is set to Silent, it will not display any audio or

visual indicators during Emergency mode, or allow any

received calls to sound through the radio’s speaker, until the

programmed hot mic transmission period is over, and you

press the PTT button.

If your radio is set to Silent with Voice, it will not display any

audio or visual indicators during Emergency mode when you

are making the call with hot mic, but allow sound through the

radio’s speaker when the target radio responds after the

programmed hot mic transmission period is over. The

indicators will only appear when you press the PTT button.

NOTE: If the Emergency Alarm request fails, the radio does

not retry to send the request, and enters the hot mic

state directly.



NAG-LACR.book Page 56 Tuesday, January 10, 2012 10:33 AM