User's Guide

English
4
Attaching the Universal Connector Cover
(Dust Cover)
The universal connector is located on the antenna side of the
radio. It is used to connect MOTOTRBO accessories to the
radio.
Insert the slanted end of
the cover into the slots
above the universal
connector. Press
downward on the cover to
seat the dust cover
properly on the Universal
Connector.
Secure the dust cover to
the radio by pushing the
latch upwards.
To remove the dust cover,
push the latch downwards.
Lift the cover up and slide
down the dust cover from
the universal connector to
remove it.
Replace the dust cover when the universal connector is not in
use.
Attaching the Accessory Connector
The accessory connector is
to be secured to the
universal connector on the
antenna side of the radio.
To attach the accessory
connector, refer to the steps
shown in the diagram.
To remove the accessory
connector, refer to the steps
shown in the diagram.
1
2
3
1
2
3
2
3
1
NAG-LACR.book Page 4 Thursday, April 12, 2012 5:58 PM