User's Manual

English
Your radio must have the Privacy feature
enabled on the channel to send a privacy-
enabled transmission. Only target radios with the
same Privacy Key OR the same Key Value and
Key ID as your radio will be able to unscramble
the transmission.
Making an All Call
NOTE: Your radio must be programmed to allow
you to use this feature. Users on the
channel cannot respond to an All Call.
Long press the programmed number key and
proceed to Step 2.
OR
Follow the procedure below.
1 Turn the Channel Selector Knob to select the
channel with the active All Call group alias or
ID.
2 Hold the radio vertically 1 to 2 inches (2.5 to
5.0 cm) from your mouth.
3 Press the PTT button to make the call. The
LED lights up solid green. The display shows
the All Call group alias or ID, and the All Call
icon.
4 Wait for the Talk Permit Tone to finish (if
enabled).
OR
Wait for the PTT Sidetone to finish (if
enabled).
5 Speak clearly into the microphone.
6 If there is no voice activity for a programmed
period of time, the call ends.
When you receive an All Call, a message
appears and remains on your radio’s display until
the call ends. You will not be able to continue
with any menu navigation or editing until the call
ends.
Once the All Call ends, the radio returns to the
menu prior to receiving the call.
Scanning Channels
NOTE: This feature is not applicable in Capacity
Plus.
Press the programmed Scan button to turn scan
on or off.
OR
Follow the procedure below.
1 S to access the menu.
2 Por Q to Scan and press N to select.
3 You see Scan On or Scan Off depending on
previous selection.
During scan, the LED blinks yellow and the scan
icon is displayed.
Making a
Press the programmed One Touch Access
button and proceed to Step 5.
OR
Follow the procedure below.
1 S to access the menu.
2 Por Q to Contacts. Press N to select.
3 Por Q to the required subscriber alias or
ID and press N to select.
4 Por Q to and press N to select.
5 The display shows : <Subscriber Alias
or ID>. The LED lights up solid green.
6 If the acknowledgement is received, a tone
sounds. Display shows Successful.
OR
If the acknowledgement is not received, a
tone sounds. Display shows Failed.
Sending a Quick Text Message
Press the programmed Text Message button
and proceed to Step 3.
OR
Press the programmed One Touch Access
button to send a predefined Quick Text message
to a predefined alias or ID and proceed to Step 6.
OR
Follow the procedure below.
1 S to access the menu.
2 Por Q to Messages. Press N to select.
3 Por Q to Quick Text and press N to
select.
4 Por Q to the required Quick Text and
press N to select.
5 Por Q to the required alias or ID and
press N to select.