Installation Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- Declaration of Conformity
- MOTOTRBO SLR 1000 Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 1000 Repeater
- SLR 1000 Satellite Receiver
- SLR 1000 Transceiver Board
- SLR 1000 Front Panel
- SLR 1000 Bottom Panel
- SLR 1000 Test Equipment And Service Aids
- SLR 1000 Performance Check or Testing
- SLR 1000 Programming and Tuning
- SLR 1000 Maintenance and Disassembly/Reassembly
- SLR 1000 Installation
- 10.1 Pre-Installation Considerations
- 10.2 SLR 1000 Repeater Package Contents
- 10.3 Mounting the SLR 1000 Repeater to a Wall or Ceiling
- 10.4 Mounting the SLR 1000 Repeater to a Pole
- 10.5 Electrical Connections
- 10.6 General Bonding and Grounding Requirements
- 10.7 General Cabling Requirements
- 10.8 Post Installation Checklist
- Appendix A: Accessories
- Appendix B: Replacement Parts Ordering
- Appendix C: Motorola Solutions Service Centers
- Appendix D: SLR 1000 Series Third-Party Controllers
- Appendix E: MOTOTRBO Repeater EME Assessment
- Glossary of Terms and Acronyms
- Alert tone
- Analog
- ASIC
- AUX
- Band
- CTCSS
- Clear
- Conventional
- CPS
- Default
- Digital
- DPL
- DSP
- EIA
- ESD
- EU
- FCC
- FM
- Frequency
- FRU
- FSK
- GNSS
- GPIO
- IC
- IF
- I/O
- kHz
- LCD
- LED
- MDC
- MHz
- MISO
- MOSI
- PA
- PC Board
- PFC
- PL
- Programming Cable
- PTT
- Radio Management
- Receiver
- Repeater
- RF
- RSSI
- Rx
- SCM
- SELV
- Signal
- SINAD
- SLR
- Spectrum
- SPI
- Squelch
- TOT
- TPL
- Transceiver
- Transmitter
- Trunking
- Tx
- UHF
- USB
- VCO
- VCTCXO
- VHF
- VIP
- VSWR
- WLAN
Return to Process
SLR 1000 Satellite Receiver on page 45
2.4
Satellite Receiver Specifications
The specifications of the SLR 1000 Satellite Receiver are identical to the SLR 1000 Repeater, with the
exception that all transmitter related specifications are not applicable.
See the SLR 1000 Repeater Repeater Specifications
on page 37 for more details.
Return to Process
SLR 1000 Satellite Receiver on page 45
2.5
Satellite Receiver Configuration
The SLR 1000 Satellite Receiver is configured identical, other than setting the general personality
configurations, set the Operation Mode parameter under the General Settings menu in Radio
Management (RM) to Digital Satellite Receiver.
To locate where the Operation Mode field is located in the RM, see the following figure.
Figure 10: Operation Mode Configuration for Satellite Receiver Functionality
Return to Process
SLR 1000 Satellite Receiver on page 45
2.6
Basic Satellite Receiver Level Troubleshooting – RDAC and
LEDs
The SLR 1000 Satellite Receiver troubleshooting procedures are similar to the SLR 1000 Repeater
with regards to the control, transmitter, and receiver sub-systems.
See the SLR 1000 Receiver Basic Repeater Level Troubleshooting – RDAC and LEDs on page 41 for
more details.
MN003557A01-AF
Chapter 2: SLR 1000 Satellite Receiver
46