Installation Manual

Figure 48: Radio Management Configuration for L3276 Tone Remote Adapter (for a 2-Channel
Remote Control)
NOTICE: This configuration is considered typical. The L3276 Remote Tone Adapter provides
alternate configurations that are supported by the repeater as well. See the L3276 Remote
Tone Adapter manual for additional details.
Return to Process
Tone Remote Adapter on page 127
D.2.4
Tone Remote Adapter Settings
The input and output levels of the Tone Remote Adapter should be adjusted per the Tone Remote
Adapter’s instructions. The following sections give a brief overview of the high-level characteristics and
typical Tone Remote Adapter settings for configuration with the SLR 1000 Repeater .
Return to Process
Tone Remote Adapter on page 127
Related Links
Radio Rx on page 130
Radio Tx on page 131
Channel Steering on page 131
Monitoring on page 131
PTT on page 131
Wildcard 1 (optional) on page 131
D.2.4.1
Radio Rx
The Receiver audio yields 330 mV rms into 50 kΩ with an RF input signal deviating at 60% RSD. With
the Remote Tone Adapter's own loading impedance, the "Radio Rx" signal delivered to the phone
patch is at a high enough drive level to leave jumper S10 in the factory default position (position is
"out").
Return to Process
Tone Remote Adapter Settings on page 130
MN003557A01-AF
Appendix
D: SLR 1000 Series Third-Party Controllers
130