Installation Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- Declaration of Conformity
- MOTOTRBO SLR 1000 Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 1000 Repeater
- SLR 1000 Satellite Receiver
- SLR 1000 Transceiver Board
- SLR 1000 Front Panel
- SLR 1000 Bottom Panel
- SLR 1000 Test Equipment And Service Aids
- SLR 1000 Performance Check or Testing
- SLR 1000 Programming and Tuning
- SLR 1000 Maintenance and Disassembly/Reassembly
- SLR 1000 Installation
- 10.1 Pre-Installation Considerations
- 10.2 SLR 1000 Repeater Package Contents
- 10.3 Mounting the SLR 1000 Repeater to a Wall or Ceiling
- 10.4 Mounting the SLR 1000 Repeater to a Pole
- 10.5 Electrical Connections
- 10.6 General Bonding and Grounding Requirements
- 10.7 General Cabling Requirements
- 10.8 Post Installation Checklist
- Appendix A: Accessories
- Appendix B: Replacement Parts Ordering
- Appendix C: Motorola Solutions Service Centers
- Appendix D: SLR 1000 Series Third-Party Controllers
- Appendix E: MOTOTRBO Repeater EME Assessment
- Glossary of Terms and Acronyms
- Alert tone
- Analog
- ASIC
- AUX
- Band
- CTCSS
- Clear
- Conventional
- CPS
- Default
- Digital
- DPL
- DSP
- EIA
- ESD
- EU
- FCC
- FM
- Frequency
- FRU
- FSK
- GNSS
- GPIO
- IC
- IF
- I/O
- kHz
- LCD
- LED
- MDC
- MHz
- MISO
- MOSI
- PA
- PC Board
- PFC
- PL
- Programming Cable
- PTT
- Radio Management
- Receiver
- Repeater
- RF
- RSSI
- Rx
- SCM
- SELV
- Signal
- SINAD
- SLR
- Spectrum
- SPI
- Squelch
- TOT
- TPL
- Transceiver
- Transmitter
- Trunking
- Tx
- UHF
- USB
- VCO
- VCTCXO
- VHF
- VIP
- VSWR
- WLAN
D.2.1
Tone Remote Adapter Compatibility
Model L3276 Tone Remote Adapter is compatible for all versions of
SLR 1000 Repeater software and
hardware.
Return to Process
Tone Remote Adapter on page 127
D.2.2
Tone Remote Adapter Hardware Connections
The connections between the SLR 1000 Repeater and the Tone Remote Adapter are facilitated with a
multi-conductor cable connected between the J7 the repeater back panel AUX 25-Pin connector and
that of the Tone Remote Adapter. The connection provides for the following signals:
• Transmit Audio
• Receiver Audio
• PTT
• COR
• Monitor
• Channel Steering
• Wild Card (such as Repeater Knockdown)
• Ground
Signal connections are noted in Figure 47: Signal Connections Between SLR 1000 Repeater and
Motorola L3276 25-Pin Connector for a 2-Channel Remote Control on page 128. The repeater
connector and physical Pin locations are noted in the backplane interface board section of this
manual. See Motorola L3276
25-Pin manual for its connector and physical Pin locations. The part number for a pre-fabricated
cable is noted in the repeater ordering guide.
Figure 47: Signal Connections Between SLR 1000 Repeater and Motorola L3276 25-Pin
Connector for a 2-Channel Remote Control
SLR 1000 RJ-45 L2376 Female DB25
TX Audio
Ground
RXAudio
GPI6
GPO7
GPI9
GPI4
Tx
AGND
Rx-
Rx+
PTT
Carrier In
Monitor
Channel Steer 0
1
4
7
2
5
6
8
12
4
11
3
6
10
7
8
MN003557A01-AF
Appendix
D: SLR 1000 Series Third-Party Controllers
128