Installation Manual

• Ensure that the installation area can safely support the weight of the repeater.
• Burn hazard. The metal housing of the product may become extremely hot. Use caution
when working around the equipment.
•
RF energy burn hazard. Disconnect power to prevent injury before disconnecting and
connecting antennas.
•
Shock hazard. The outer shields of all Tx and Rx RF cables outer shields must be grounded per
Motorola Solutions R56 manual.
• All Tx and Rx RF cables shall be connected to a surge protection device according to Motorola
Solutions R56 manual. Do not connect Tx and Rx RF cables directly to an outside antenna.
•
Attention
Compliance with National and International standards and guidelines for human exposure to
Electromagnetic Energy (EME) at Transmitter Antenna sites generally requires that persons having
access to a site shall be aware of the potential for exposure to EME and can exercise control of
exposure by appropriate means, such as adhering to warning sign instructions. See this installation
manual and Appendix A of Motorola Solutions R56.
This product complies with the requirements set forth by the European R&TTE regulations and
applicable CENELEC standards concerning human exposure to Electromagnetic Energy (EME) at
Transmitter Antenna sites. MOTOTRBO Repeater EME Assessment
on page 133 in this manual
includes an EME exposure analysis of a typical system configuration for this product.
For a different system configuration than the typical configuration, compliance with applicable EME
exposure standards (current versions of the EN50384, EN50385, IEC/IEEE 62704-2, and United
States Federal Communication Commission, “Evaluating compliance with FCC guidelines for
human exposure to radio frequency electromagnetic fields,” OET Bulletin 65 (Ed. 97-01), August
1997. Supplement C (Edition 01-01) to US FCC OET Bulletin 65 (Edition 97-01), “Additional
Information for Evaluating Compliance of Mobile and Portable Devices with FCC Limits for Human
Exposure to Radio frequency Emissions,” June 2001 standards for occupational and general public
exposure, respectively) can be evaluated by either employing the indoor or outdoor methods
illustrated in the typical system configuration EME exposure analysis included in MOTOTRBO
Repeater EME Assessment on page 133 in this manual, or employing another suitable method
among those described in the current version of the EN50383 standard.
Once the occupational and general public compliance boundaries are determined, means to ensure
that workers and people are outside the respective boundaries, for instance using appropriate
signage or restricted access, should be implemented; if this is not possible or practically achievable
for the specific system configuration, the configuration should be modified in order to make it
possible. The R56 Standards and Guidelines for Communications Sites manual (which can be
obtained by ordering CDROM 9880384V83) provides examples of signage that can be used to
identify the occupational or general public compliance boundaries.
Refer to product specific manuals for detailed safety and installation instructions. Manuals can be
obtained with product orders, downloaded from https://businessonline.motorolasolutions.com, or
purchased through the Motorola Solutions Aftermarket & Accessory Department.
This is a class A product. In a domestic environment, this product may cause radio interference in
which case the user may be required to take adequate measures.
MN003557A01-AF
Notice General Safety and Installation
Standards and Guidelines
6