Installation Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- Declaration of Conformity
- Declaration of Compliance for the Use of Distress and Safety Frequencies
- MOTOTRBO SLR 1000 Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 1000 Repeater
- SLR 1000 Satellite Receiver
- SLR 1000 Transceiver Board
- SLR 1000 Front Panel
- SLR 1000 Bottom Panel
- SLR 1000 Test Equipment And Service Aids
- SLR 1000 Performance Check or Testing
- SLR 1000 Programming and Tuning
- SLR 1000 Maintenance and Disassembly/Reassembly
- SLR 1000 Installation
- 10.1 Pre-Installation Considerations
- 10.2 SLR 1000 Repeater Package Contents
- 10.3 Mounting the SLR 1000 Repeater to a Wall or Ceiling
- 10.4 Mounting the SLR 1000 Repeater to a Pole
- 10.5 Electrical Connections
- 10.6 General Bonding and Grounding Requirements
- 10.7 General Cabling Requirements
- 10.8 Post Installation Checklist
- Appendix A: Accessories
- Appendix B: Replacement Parts Ordering
- Appendix C: Motorola Solutions Service Centers
- Appendix D: SLR 1000 Series Third-Party Controllers
- Appendix E: MOTOTRBO Repeater EME Assessment
- Glossary of Terms and Acronyms
- Alert tone
- Analog
- ASIC
- AUX
- Band
- CTCSS
- Clear
- Conventional
- CPS
- Default
- Digital
- DPL
- DSP
- EIA
- ESD
- EU
- FCC
- FM
- Frequency
- FRU
- FSK
- GNSS
- GPIO
- IC
- IF
- I/O
- kHz
- LCD
- LED
- MDC
- MHz
- MISO
- MOSI
- PA
- PC Board
- PFC
- PL
- Programming Cable
- PTT
- Radio Management
- Receiver
- Repeater
- RF
- RSSI
- Rx
- SCM
- SELV
- Signal
- SINAD
- SLR
- Spectrum
- SPI
- Squelch
- TOT
- TPL
- Transceiver
- Transmitter
- Trunking
- Tx
- UHF
- USB
- VCO
- VCTCXO
- VHF
- VIP
- VSWR
- WLAN
Table 28: Outdoor EME Compliance Distances Based on the UHF Evaluation Example (applicable
antenna: DB408-B)
Exposure Condition
Based on the Peak
1-g SAR FCC Limit
Based on the Peak
10-g SAR ICNIRP
Limit
Based on the Whole-
Body SAR Limit
General public expo-
sure
20 cm 20 cm 20 cm
Occupational-type ex-
posure
20 cm 20 cm 20 cm
The compliance distances in the preceding tables were derived based on the applicable IEC
62232:2017 standard [10] Specific Absorption Rate (SAR) prediction formulas. In several cases, the
derived distance of 20 cm is very conservative because it is a minimum distance for the validity of the
mentioned SAR formulas [10]. This distance may be reduced significantly for occupational-type
exposure conditions by carrying out an analysis based on SAR measurements.
Table 29: Indoor EME Compliance Distances Based on the VHF Evaluation Example (applicable
antenna:HKAD4003, HKAD4004 and HKAD4005)
Exposure Condition
Based on the ICNIRP reference Levels and
FCC MPE Limits
General public exposure 59 cm
Occupational-type exposure 27 cm
The compliance distances in the table above were derived based on the applicable IEC 62232:2017
standard [10] and U.S. FCC OET Bulletin [2[ power density prediction formulas. These formulas are
conservative and the distance may be reduced by carrying out analysis based on SAR measurements.
Return to Process
MOTOTRBO Repeater EME Assessment on page 133
E.2
Device Characteristics
The technical characteristics of the Model
FCC ID ABZ99FT3096 AAR11JDGANQ1AN and FCC ID
ABZ99FT4100 AAR11SDGANQ1AN are as follows:
• Transmit Frequency Range: 136-174 MHz and 400–512 MHz
• Maximum Power: 10 W
• Maximum Duty Cycle: 100%
• Antenna Information is summarized in the following table:
Table 30: Antenna Characteristics
Kit or
Model
Number
Frequen-
cy MHz Type
Peak Gain
dBi Length m
3 dB Ele-
vation
Beam-
width, deg
3 dB Azi-
muth
Beam-
width, deg
HKAD4003 136-154 monopole -1.8 0.49* 100 Omni
HKAD4004 146-164 monopole -1.3 0.49* 100 Omni
MN003557A01-AF
Appendix
E: MOTOTRBO Repeater EME Assessment
134