Installation Guide

1-2 Introduction Mobile Radio Description
1.1.2 Dimensions
Figure 1-1, Figure 1-2, Figure 1-3 and Figure 1-4 show the basic dimensions of the dash mount
trunnion of the mobile radio.
When installing the radio, make sure to plan the installation carefully and leave additional room in the
rear of the radio for cabling and accessory connections; in the front of the radio for access, controls,
and cabling; and to the sides of the radio so that you may access and install the trunnion wing
screws.
NOTE: The MOTOTRBO XPR 2000 Series mobile models use wing screws with thread length of
0.39 inches (9.9 mm) to secure the radio to the mounting trunnion.
Figure 1-1 Front View of Dash Mount Trunnion for MOTOTRBO XPR 2000 Series mobiles
Figure 1-2 Side View of Dash Mount with Low Profile Trunnion for MOTOTRBO XPR 2000 Series mobiles
8.2”
6.9”
5.5”
5.3”
1.7”
2.4”