User's Manual

Advanced Features
English
36
Setting and Editing Priority for an Entry in the Scan
List
Procedure:
1 g to access the menu.
2 f or h to Scan and press g to select.
3 f or h to Scan List and press g to select.
4 f or h to the required alias or ID and press g to
select.
5 f or h to Edit Priority and press g to select.
6 f or h to the required priority level and press g to
select.
7 The display shows positive mini notice before returning to
the previous screen.
8 The priority icon appears left of the member’s name.
There is no priority icon if priority is set to None.
Scan
When you start a scan, your radio cycles through the
programmed scan list for the current channel looking for voice
activity.
The yellow LED blinks and the scan icon appears on the status
bar.
During a dual mode scan, if you are on a digital channel, and
your radio locks onto an analog channel, it automatically
switches from digital mode to analog mode for the duration of
the call. This is also true for the reverse.
There are two ways of initiating scan:
• Main Channel Scan (Manual): Your radio scans all the
channels/groups in your scan list. On entering scan, your
radio may – depending on the settings – automatically start
on the last scanned “active” channel/group or on the channel
where scan was initiated.
• Auto Scan (Automatic): Your radio automatically starts
scanning when you select a channel/group that has Auto
Scan enabled.
NOTE: This feature is not applicable in Capacity Plus and
Linked Capacity Plus.

NAG.book Page 36 Thursday, January 3, 2013 3:15 PM