Installation Guide
Table Of Contents
- Chapter 1 Introduction
- 1.1 Mobile Radio Description
- 1.2 Standard Configurations
- Chapter 2 Installation Details for Standard Configurations
- 2.1 Planning the Installation
- 2.2 Radio Mounting
- 2.3 Power Cable
- 2.4 Ignition Sense Cable
- 2.5 Antenna Installation
- 2.6 Microphone Hang-Up Clip
- 2.7 Completing the Installation
- Chapter 3 Options and Accessories Installation
- 3.1 Accessory Installation
- Chapter 4 Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improve the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- A.1 Basic Ordering Information
- A.2 Motorola Online
- A.3 Mail Orders
- A.5 Fax Orders
- A.6 Parts Identification
- A.7 Product Customer Service
- B.1 Servicing Information
- B.2 Motorola Service Center
- B.3 Motorola Federal Technical Center
- B.4 Motorola Canadian Technical Logistics Center
Draft
Chapter 3 Options and Accessories Installation
3.1 Accessory Installation
The accessories must be installed through the rear accessory connector that is located on the rear of
the radio, adjacent to the power connector. Most of the Motorola-approved accessories are supplied
with female terminals crimped to a 20-gauge wire specifically designed to fit the plug of the rear
accessory connector.
Insert the female terminal into the accessory connector assembly in the appropriate locations. The
accessory connector assembly is provided together with the accessory. Connect the accessory
connector assembly to the rear accessory connector on the back of the mobile. Do not use other
generic terminals in the plug. Generic terminals can cause electrical intermittences and may cause
damage to the plug.
Figure 3-1 Location of the Rear Accessory Connector
Rear Accessory
Connector