Installation Guide

Draft
Chapter 1 Introduction
This manual covers the installation procedures for CM 2000 Series and XPR 2000 Series Mobile
Radios and accessories required to complete the radio system. The radio system consists of a
control head, radio, antenna, microphone, speaker, cabling, and accessories.
1.1 Mobile Radio Description
1.1.1 Overview
1.1.2 Dimensions
Figure 1-1, Figure 1-2, Figure 1-3 and Figure 1-4 show the basic dimensions of the dash mount
trunnion of the mobile radio.
When installing the radio, make sure to plan the installation carefully and leave additional room in the
rear of the radio for cabling and accessory connections; in the front of the radio for access, controls,
and cabling; and to the sides of the radio so that you may access and install the trunnion wing
screws.
Model Description
CM 2300
Numeric Display model with 2 programmable buttons and a
2-character 7-segment display.
CM 2500
Display model with 4 programmable buttons and a dot-matrix
LCD.
XPR 2500
Display model with 4 programmable buttons, dot-matrix LCD,
and premium system software features available.
Figure 1-1 Front View of Dash Mount Trunnion for MOTOTRBO CM 2000 Series and XPR 2000 Series
mobiles
8.2”
6.9”