User's Manual
Table Of Contents
- Declaration of Conformity
- Contents
- Important Safety Information
- Firmware Version
- Computer Software Copyrights
- Handling Precautions
- Notes
- How to Use This Guide
- What Your Dealer/System Administrator Can Tell You
- Charging the Battery
- Attaching the Battery
- Attaching the Antenna
- Attaching the Belt Clip
- Attaching the Universal Connector Cover (Dust Cover)
- Attaching the Accessory Connector
- Powering Up the Radio
- Adjusting the Volume
- Radio Controls
- Programmable Buttons
- Accessing the Programmed Functions
- Push-To-Talk (PTT) Button
- Switching Between Conventional Analog and Digital Mode
- Capacity Plus
- Display Icons
- Call Icons
- Advanced Menu Icons
- Mini Notice Icons
- LED Indicator
- Audio Tones
- Indicator Tones
- Making and Receiving Calls
- Selecting a Site
- Selecting a Zone
- Selecting a Radio Channel, Subscriber ID, or Group ID
- Receiving and Responding to a Radio Call
- Making a Radio Call
- Stopping a Radio Call
- Talkaround
- Monitoring Features
- Radio Check
- Scan Lists
- Scan
- Vote Scan
- Contacts Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Analog Message Encode
- Analog Status Update
- Privacy
- Dual Tone Multi Frequency (DTMF)
- IP Site Connect
- Security
- Lone Worker
- Password Lock Features
- Notification List
- Utilities
- Turning the Radio Tones/Alerts On or Off
- Setting the Tone Alert Volume Offset Level
- Turning the Talk Permit Tone On or Off
- Setting the Power Level
- Adjusting the Display Brightness
- Controlling the Display Backlight
- Setting the Squelch Level
- Turning the Introduction Screen On or Off
- Language
- Turning the LED Indicator On or Off
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Voice Announcement
- Call Forwarding
- Menu Timer
- Analog Mic AGC
- Digital Mic AGC
- Intelligent Audio
- Accessing General Radio Information
- Front Panel Configuration (FPC)
- Accessories
- Batteries and Chargers Warranty
- Limited Warranty
Declaration of Conformity
English
ii
Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
LKP_NAG-LACR.book Page ii Tuesday, September 6, 2011 5:01 PM