Installation Manual
Table Of Contents
- CM200/CM300/PM400 Installation Manual
- Table of Contents
- Installation Requirements For Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Information for Vehicles with Electronic Anti-Lock/Anti-Skid Brakes
- Chapter 1 Introduction
- Chapter 2 DC Power Cable Installation
- Chapter 3 Trunnion Installation
- Chapter 4 Antenna Installation
- Chapter 5 Installation Options
- Chapter 6 Accessory Connections
- Chapter 7 Noise Sources
- Chapter 8 Operation of a Conventional Ignition System
- Chapter 9 Detection of Noise Sources
- Chapter 10 Noise Reduction Techniques
Information for Vehicles with Electronic Anti-Lock/Anti-Skid Brakes v
8. Repeat Step 7, except do so while speaking into the microphone.
9. Release the brake pedal completely and accelerate the vehicle to a speed of 20 miles (30 kilometers) per
hour. Ensure that a minimum of two vehicle lengths is maintained between the front of the vehicle and any
object in the vehicle’s forward path. Have another person key the radio transmitter, and verify that the vehi-
cle can be braked properly to a sudden (panic) stop while NOT speaking into the microphone.
10. Repeat Step 9, except do so while speaking into the microphone.
11. Repeat Steps 9 and 10, except use a vehicle speed of 30 miles (50 kilometers) per hour.
For radios installed in vehicles fuelled by liquefied petroleum gas, refer to the (U. S.)
National Fire Protection Association standard, NFPA 58, for storage, handling, and/or
container information.
For a copy of the LP-gas standard, NFPA 58, contact the National Fire Protection
Association, One Battery Park, Quincy, MA,.
!
WARNING