User's Manual

Turning On the Radio
• Turn On/Off/Volume Control knob clockwise. If the
radio successfully powers up, you will hear the Self
Test Pass tone and see the LED light green. If the
radio fails to power up, you will hear the Self Test
Fail tone.
Turning Off the Radio
• Turn On/Off/Volume Control knob counter-
clockwise until you hear a click.
Adjusting the Radio Volume
1. Press and hold Volume Set button (preprogrammed
by your dealer) until you hear a continuous tone.
2. Turn On/Off/Volume Control knob to adjust volume
level.
3. Release Volume Set button at desired volume level.
Selecting a Radio Channel
• Turn Channel Selector knob clockwise or counter-
clockwise to reach desired channel.
Sending a Call
1. With radio on, turn Channel Selector knob to
required channel.
2. Press PTT and speak clearly with mouth about 2.5
to 5 cm (1 to 2 inches) away from microphone.
3. Release PTT when call is completed.
Receiving a Call
1. Turn on the radio.
2. Adjust the volume level.
3. Select the radio channel.
Programmable Buttons’ Audio Indicators
Deleting a Nuisance Channel
1. With radio on a Nuisance Channel, press and hold
the preprogrammed Nuisance Delete button until
you hear a tone.
2. Release the Nuisance Delete button.
Programmable
Buttons
Positive
Indicator
Tone
Negative
Indicator
Tone
Scan
Start Scan
operation
Stop Scan
operation
Power Level
Radio transmits
at high power
Radio transmits
at low power
Squelch
Radio operates
in tight squelch
Radio operates
in normal
squelch
Repeater/
Talkaround
Radio DOES
NOT use the
repeater
Radio uses the
repeater
12_QR-Card.fm Page 32 Thursday, September 19, 2002 5:17 PM