User's Manual
Table Of Contents
- PR400 Portable Radio
- English
- French
- Droits d’auteur du logiciel informatique
- Table Des Matières
- Sécurité
- Introduction
- Schéma de la radio
- Mise en route
- Mise sous tension et hors tension de la radio
- Réglage du volume
- Sélection d’un canal radio
- Réception
- Surveillance
- Transmission
- Mode Répéteur ou Conversation directe
- Fonctionnement en mode VOX
- Activation/Désactivation de l’effet local du casque
- Escalert
- Sélection du niveau de réglage silencieux
- Réglage du niveau de puissance
- Activation et désactivation de la carte d’option
- Appels radio
- Balayage
- Garantie
- Accessoires
- Aide-mémoire de la radio PR400
20
English
GETTING STARTED
RECEIVE
MONITOR
It is important to monitor for traffic before
transmitting to ensure that you do not “talk
over” someone who is already transmitting.
Permanent Monitor
1 Turn your radio on.
2 Adjust the radio’s volume (see page 19).
3 Switch to the desired channel.
• Make sure the PTT button is released.
4 Listen for voice activity.
• The LED indicator flashes red while your
radio is receiving.
5 To respond, hold the radio vertically 1 to 2
inches (2.5 to 5cm) from your mouth. Press
the PTT button to talk; release it to listen.
1 Press and hold the preprogrammed Monitor
button to access channel traffic.
• If no activity is present, you will hear “white
noise.”
2 Once channel traffic has cleared, proceed
with your call by pressing the PTT button.
1 A long press of the preprogrammed Monitor
button places the radio in Permanent Monitor
mode.
• You hear a good key tone.
2 A short press of the Monitor button cancels
Permanent Monitor mode and returns the
radio to normal operation.
02_GetStarted.fm Page 20 Thursday, August 7, 2003 12:10 PM