User's Guide

6.12.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can also exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the preprogrammed Emergency button.
6.12.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. Check with your dealer or system administrator
for more information on dispatch console supporting this feature.
Procedure:
1 Perform one of the following actions:
If… Then…
If the emergency mode is
initiated by other radios,
press and hold the Accy No-Dot Button (Purple) button
and press the Emergency button.
If the emergency mode is
initiated by the Supervisor,
Perform one of the following actions:
• Press and hold the Emergency button.
• Press and hold the Accy No-Dot Button (Purple) and
press the Emergency button.
• Wait for console to clear emergency.
NOTICE: The following buttons combinations are supported:
• Radio Accy No-Dot Button (Purple) and Emergency button.
• Radio Accy No-Dot Button (Purple) and accessory Orange button.
• Accessory 1-Dot Button and radio Emergency button.
• Accessory 1-Dot Button and accessory Orange button.
6.12.5
Sending an Emergency Alarm
When and where to use:This feature allows you to send a data transmission, which identifies the
radio sending the emergency, to the dispatcher.
Procedure:
1 Press the preprogrammed Emergency button.
A tone sounds and the display alternates EMERGENCY and the home display. A dispatcher
acknowledgment ACK RECEIVED display follows. For trunking system, the radio also sounds a
high-pitched tone that indicates the alarm has been received by the trunked system’s central
controller.
2 Press and hold the Emergency button or the PTT button to return to normal operation.
6875947M01-HP
Chapter 6: Advanced Features
62