User's Guide

This capability does not apply to priority channels or the designated transmit channel.
Procedure:
When the radio is locked onto the channel to be deleted, or to NUIS and press the Menu
Select button directly below NUIS.
The radio continues scanning the remaining channels in the list.
6.7.4
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, perform one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to the original channel.
• Turn off the radio and then turn it on again.
6.7.5
Changing Priorities Status While Scan is On
When and where to use:
While the radio is scanning, the dynamic priority change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One channel) to the Priority-Two channel.
This change remains in effect until scan is turned off. Scan then reverts to the preprogrammed
(original) setting.
Procedure:
1 Press the Menu Select button directly below DYNP to change the priority of a non-priority
channel in the scan list to Priority-Two.
2 Press
momentarily to exit the scan list and resume scanning.
6.7.6
Restoring Priorities in a Scan List
Procedure:
To restore the original channel priorities in a scan list, perform one of the following actions:
• Turn scan off, and then on.
• Change channels.
• Turn off the radio, and then turn it back on.
6.7.7
Using the Hang Up Box (HUB)
Procedure:
1 To temporarily suspend Scan Mode operation, remove the microphone from the Hang Up Box
(HUB).
You are allowed to use the control head while scan is suspended. However, Priority Member
scanning is not suspended. This feature applies to all Scan Lists and Scan Types. Scan is
6875947M01-HP
Chapter 6: Advanced Features
55