Installation Instructions

Figure 55: O3 Control Head
1
2 3 4 5
No. Description
1 Top
2 Left
3 Front
4 Right
5 Back
The recommended mounting surface for the control unit is on the center console. Figure 57: Hang-Up
Clip Installation Exploded View on page 61 shows how the hang-up clip control head, and cables
should be installed for the O3 control head.
A mounting clip, which allows the control head to be mounted, is supplied together with the control
head.
Procedure:
1 Use the provided mounting clip to determine the location of the two screw holes.
2 Drill 7/16” deep holes for the upper and lower screws.
3 Use the tapping screw provided to install the mounting clip.
MN005720A01-AB
Chapter 2: Standard Configurations
60