User's Guide

If... Then...
If you change to a channel/mode with no Emer-
gency capability while in Emergency operation,
the following occurs:
• The display shows No emergency.
• A continuous low-pitched tone sounds until
you select a valid Emergency channel/mode
or until you disable the Emergency opera-
tion.
If you change to a channel/mode with Emergen-
cy capability while in Emergency operation,
the Emergency Alarm and/or Emergency Call
continues on the new channel/mode.
If the radio is out-of-range of the system or the
emergency alarm is not acknowledged,
a tone sounds and the display shows No ac-
knowledge.
6.9.2
Emergency Keep-Alive
This feature prevents the radio from being turned off when it is in Emergency mode. If this feature is
enabled, you are required to exit Emergency mode before turning off your radio.
6.9.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can also exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the preprogrammed Emergency button.
6.9.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. Check with your dealer or system administrator
for more information on dispatch console supporting this feature.
Procedure:
1 Perform one of the following actions:
If… Then…
If the emergency mode is
initiated by other radios,
press and hold the Accy No-Dot Button (Purple) button
and press the Emergency button.
If the emergency mode is
initiated by the Supervisor,
Perform one of the following actions:
• Press and hold the Emergency button.
• Press and hold the Accy No-Dot Button (Purple) and
press the Emergency button.
• Wait for console to clear emergency.
NOTICE: The following buttons combinations are supported:
• Radio Accy No-Dot Button (Purple) and Emergency button.
68012006034-EM
Chapter 6: Advanced Features
59