Instruction Manual

No. Description
4 Control Head Power (Red)
5 Control Head Power Fuse
6 Control Head Ground (Black)
7 Ignition Sense (ACC)
8 Emergency Cable Shorting Plug
9 Headset Sporting Plug
10 Accessory Cable Headset Connector
11 Accessory Cable Emergency and External Alarm Connector
5.11.2
Installing the Transceiver
Prerequisites:
Install the transceiver in the weather-resistant enclosure as follows (see Figure 113: Installing the
Transceiver on page 119).
Procedure:
1 Install the mounting trunnion and loose ends of the four ground straps to the radio-mounting
plate, using four screws, flat washers, and external-tooth lock washers (see Figure 113:
Installing the Transceiver on page 119). The ground straps must be sandwiched between the flat
washers and lock washers. The lock washer must be against the trunnion. The flat washer must
be under the screw head.
2 Attach the transceiver to the mounting trunnion and secure with the two screws provided.
3 Connect the control cable to the front of the transceiver. Ensure the control cable connector
screws are tightened.
4 Attach the accessory connector to the transceiver. Plug in the power connector.
5 Install the grommet around the cables and push the grommet into the cable-routing hole of the
weather-resistant enclosure.
MN005720A01-AB
Chapter 5: Motorcycle Radio Installation
118