Instruction Manual

5.11.1
Installing Cabling in the Enclosure
Follow the procedure to position the cabling in the weather-resistant enclosure.
Procedure:
1 Run the speaker, power, control-head, and ignition sense cables into the enclosure.
2 Lay the excess cable length between the radio mounting bosses in an S configuration as shown
in Figure 112: Installing Cables on page 117. Do not coil any excess cable. Use the supplied tie
wraps to bundle cable as shown.
NOTICE: If the extra cable length is not sufficient to match the illustrated cable routing,
then match the illustration as closely as possible.
3 Connect the speaker cable to the accessory cable connector.
NOTICE: The accessory-cable emergency connector is shipped with a shorting plug
installed. The headset connector is also shipped with a shorting plug installed. If an
emergency switch and/or headset is not used, the plugs must remain in. If an emergency
switch and/or headset is used, remove the shorting plug and discard.
4 Install the mounting plate in position on top of the cables installed above. Take care not to
damage or pinch the cables when securing the mounting plate in position.
NOTICE: The control-head cable plug should be at the forward end of the enclosure, and
the power-cable, speaker-cable, and accessory-cable plugs should be at the rear of the
enclosure.
Figure 112: Installing Cables
1
2
3
4
5
6
7
8
9
10
11
No. Description
1 Transceiver Power Cable
2 Accessory Cable
3 Control Cable (CAN)
MN005720A01-AB
Chapter 5: Motorcycle Radio Installation
117