Instruction Manual

No. Description
1 Cable Clamp
2 Coaxial Cable
3 Attach to Antenna Connector on Radio
14 After routing the cable, allow enough of the cable to reach the radio antenna connector and cut
off any excess length of the cable.
15 To install the connector, refer to the Antenna Installation Manual.
5.8
Installing the Antenna
Procedure:
1 Connect the appropriate antenna connectors to the antenna receptacles on the radio. Tighten
the coupling until fully engaged.
IMPORTANT: Antenna Placement and Cable Routing as described inside the Antenna
Installation Manual is not applicable for the APX radio series.
5.9
Cable Routing
Five cables must be installed to interconnect the components of the radio system as shown in the
following figure. The antenna cable is routed away from the other cables inside the enclosure hinged
cover (see Installing Antenna Base and Cables on page 110). The four remaining cables, routed along
the motorcycle frame, are described in the following paragraphs.
NOTICE: Antenna Hole Placement and Cable Routing information in the Antenna Installation
Manual is not applicable to the APX series.
Removal of the fuel tank and seat from the motorcycle facilitates routing the cables along the
frame. Motorcycles with consoles attached to fuel tanks require routing cables between console
and fuel tank. In this case the tank is not removed.
MN005720A01-AB
Chapter 5: Motorcycle Radio Installation
113