Instruction Manual

Chapter 6
Finishing the Installation
This chapter provides the cable connection and dust cover installation procedure.
6.1
Cable Connection
The topic provides the procedure for control heads cable connection.
6.1.1
Connecting the Cables for O2 Control Head
Procedure:
1 Remove the control head from its mounting trunnion.
2 Plug the radio CAN cable into the proper location on the back of the control head (see Figure
47: O5 Control Head Installation Exploded View (Also applicable for O2, O7 and E5 Control
Heads) on page 53 and Figure 49: O5 Control Head Rear View (Also applicable for O2, O7 and
E5 Control Heads) on page 55).
The connectors “click” when snapped into place. The control head model can have the
microphone plugged into the lower left corner of the control head front panel.
3 Connect the plug from the speaker lead to the mating connector that comes out from the power
cable.
4 Plug the VIP connector into the correct location an the back of the control head.
5 Connect the CAN cable to the proper location on the radio.
NOTICE: Connector-protective covers are provided with the radio. They should be used
for added environmental robustness.
6 Ensure that the control head and microphone PTT switches are turned off.
7 Install the 15 A fuse in the radio power cable fuseholder and the 3 A or 4 A fuse in the ignition
sense cable fuseholder.
8 Turn on the radio at the control head and verify proper operation of all controls and indicators.
Radio operation in some installations requires turning on the ignition sense.
9 Perform a complete operational check of the radio.
10 Dress the control and power cables out of the way to prevent damage (pull any excess cable
into the trunk area), securing the cables with clamps and tie wraps where necessary.
6.1.2
Connecting the Cables for O3 Control Head
Procedure:
1 Unplug the CAN coiled cable connector from the Transceiver Interface.
MN005720A01-AB
Finishing the Installation
125