Instruction Manual

5.17
Emergency Switch Wiring
Figure 120: Emergency Switch Wiring Diagram
ACCESSORIES
CONNECTOR
J2 IN DASH MOUNT
J100 IN REMOTE MOUNT
PIN 14
PIN 15
NOTE 1
SPST NORMALLY CLOSED
EMERGENCY SWITCH
NOTE 1: REMOVE BLACK JUMPER WIRE INSIDE
ACCESSORY CONNECTOR HOUSING.
INSERT WIRES FROM EMERGENCY SWITCH
GND
EMER
1
7
8
14
13
20
21
26
WARNING: Motorcycle products must have pins 1 and 2 connected together to allow the radio
to power down. Opening this connection by removing the emergency shorting plug, or pressing
the emergency switch, will turn on the radio. Failure to maintain a normally-closed path could
drain the vehicle battery if left unchecked.
Emergency-equipped radios are capable of transmitting without warning.
MN005720A01-AB
Chapter 5: Motorcycle Radio Installation
124