Installation Instructions

2.4.6

GPS/GLONASS and Wi-Fi Antenna Connection

Connect GPS and Wi-Fi antenna cable QMA plug to the radio QMA jack for GPS and Wi-Fi

respectively.

Figure 69: GPS/GLONASS and Wi-Fi Antenna Connector on the radio

2.5

Installing the Speaker

The speaker kit includes a trunnion bracket that allows the speaker to be mounted in various ways.

With the trunnion bracket, the speaker can mount permanently on the mounting surface or in

accessible firewall areas. The trunnion allows the speaker to tilt for best operation. Mount the speaker

out of the way so that the vehicle occupants cannot kick or knock around it.

Prerequisites:

CAUTION: DO NOT ground the radio speaker leads. This system has a floating speaker output

(DC voltage on both leads); damage to the audio circuit results if either lead is grounded or if

they are shorted together.

Procedure:

1 To mark the mounting hole locations, use the speaker mounting bracket as a template.

2 Use the self-drilling screws provided to fasten the trunnion.

3 Attach the speaker and fasten it to the trunnion with two wing screws.

4 Route the speaker wires under the carpet or floor covering, or behind the kick panels. Ensure

that the wires are out of the way of the occupants of the vehicle.

5 Do not submerse the 2-pin speaker connector in water nor place this connector in an area that

could have standing water.

MN005720A01-AB

Chapter 2: Standard Configurations