Installation Instructions

A mounting clip, which allows the control head to be mounted, is supplied together with the control
head.
Procedure:
1 Use the provided mounting clip to determine the location of the two screw holes.
2 Drill 7/16” deep holes for the upper and lower screws.
3 Use the tapping screw provided to install the mounting clip.
CAUTION: Shield the control head (front and back) from direct exposure to pressurized
water. The pressurized water from a hose is usually more severe than the stated test and
conditions in typical environments.
Figure 55: O3 Control Head Rear View
Figure 56: Hang-Up Clip Installation Exploded View
1
2
2
3
MN005720A01-AB
Chapter 2: Standard Configurations
59