Installation Instructions

2.2.2.1.1
Installing Remote Mount Control Head
Procedure:
1 Use the control unit trunnion as a template to mark the mounting holes; drill 5/32" holes.
If mounting on a plastic surface, use a metal backing plate.
2 Attach the trunnion bracket using all four 10-16" x 5/8" self-tapping screws provided.
3 Temporarily install the control head (adjusting for proper viewing angle) and fasten it to the
trunnion with two wing screws.
4 Test the installation to ensure that the control head feels securely locked in place while you are
pressing its buttons.
5 Finish the installation by fully tightening the screws.
Figure 47: O5 Control Head Installation Exploded View (Also applicable for O2, O7 and E5
Control Heads)
1
No. Description
1 Metal Backing Plate (Not Supplied)
MN005720A01-AB
Chapter 2: Standard Configurations
53