Installation Instructions

5.4.3.1
Installing Handlebar with Speaker and Control Head Mounted Separately
Follow the procedure when mounting the smaller control-head bracket.
Procedure:
1 Determine the location to mount the control head. Choose a location that is not only
mechanically convenient, but is located for ease of operation.
2 Securely mount the Motorola Solutions-supplied spacers, mic-cable bracket, and small control-
head bracket to the handlebars.
3 Mount the 9-pin D-connector end of the motorcycle control-head cable to the mic-cable bracket,
using two machine screws, flat washers, and nuts. Refer to Cable Routing on page 113 for
Cable routing directions.
4 Attach the control-head end of the cable to the control head and tighten the locking screws on
the connector.
5 Mount the control head to the small control-head bracket, at the proper viewing angle, using two
wing screws and tighten firmly.
5.4.4
Fuel Tank Console Installation with Speaker and Control Head
Mounted Separately
The control head may be mounted to the fuel tank console using the smaller control-head bracket and
spacers/hardware.
In this configuration, the microphone cable connector may be attached directly to the console,
eliminating the need for a custom bracket.
MN005720A01-AB
Chapter 5: Motorcycle Radio Installation
107