Assembly Instructions

Chapter 2
Standard Configurations
The radio operates only in negative ground electrical systems with a valid operating range of 10.8–16.3
VDC. Before starting the installation, ensure that the ground polarity of the vehicle is correct.
Accidentally reversing the polarity could damage the radio and cause the cable fuses to blow.
2.1
Planning the Installation
Planning is the key to fast, easy radio installation. Before starting the installation, inspect the vehicle
and determine how and where you intend to mount the antenna, radio, and accessories. Plan wire and
cable run to provide maximum protection from pinching, crushing, and overheating.
CAUTION:
Before installing any electrical equipment, check the user manual of the vehicle for warnings or
recommendations.
Authorized servicer or installer should complete the installation of this device. Failure to properly
install the device may result in damage to the device, or improper operation.
2.1.1
Installation Examples
The mobile two-way radio offers various methods of installation, with accessories placed to the vehicle
as desired. The radio can be dash or remote mounted except for the O9 control head, which can only
be mounted remotely.
Figure 25: Dash Mount Installation
Dash mount radios mounted in the middle console, on the transmission hump, or under the dash,
911
3
2
2
1
4
No. Description
1 Antenna ¼-Wavelength
2 Radio
3 Speaker
4 Battery
MN005720A01-AB
Chapter 2: Standard Configurations
32