Assembly Instructions

Installation is the same as detailed in Fuel Tank Console Installation with Speaker and Control Head
Mounted Together on page 105 and Installing Handlebar with Speaker and Control Head Mounted
Separately on page 107.
5.5
Installing the Speaker
Follow the procedure when the speaker is mounted separately from the control head.
When and where to use: The speaker bracket supplied with the speaker may be used alone if a
suitable location can be found, or if necessary, a customer-supplied bracket may be fabricated for
mounting the speaker.
NOTICE: To disable the internal speaker of the O2 Control Head, please refer to Internal
Speaker Disassembly on page 71.
Procedure:
1 Determine the location to mount the speaker and whether there is a requirement for a customer-
supplied bracket.
2 Fabricate a bracket if required. Use the Motorola Solutions-supplied speaker bracket as a
template for drilling mounting holes. Drill holes in the fabricated bracket for mounting to the
motorcycle.
3 Mount the fabricated bracket to the motorcycle chassis.
4 Mount the Motorola Solutions-supplied bracket to the fabricated bracket using two machine
screws, flat washers, lock washers, and nuts.
5 Mount the speaker to the speaker bracket using two wing screws. Refer to Cable Routing on
page 113 for Cable routing directions.
5.6
Microphone Hang-Up Clip Installation
Install the hang-up clip either on the supplied microphone extension bracket or on the side of the
speaker/control head bracket. Both methods are shown in Figure 102: Handlebar Installation with
Speaker and Control Head Mounted Together on page 104. Determine the mounting location and
install as described in the following paragraphs.
NOTICE: Wherever the hang-up clip is mounted, it must be DC grounded for proper operation.
After mounting the clip, be sure there is electrical continuity between the clip and the motorcycle
chassis.
5.6.1
Extension Bracket Mounting
Follow the procedure to mount the clip facing the operator.
Procedure:
1 Attach the bracket to the speaker/control-head bracket using two machine screws, four lock
washers, and two nuts as shown in Figure 102: Handlebar Installation with Speaker and Control
Head Mounted Together on page 104.
2 Torque nuts to 20 in-lbs torque.
3 Fasten the hang-up clip to the extension bracket using two machine screws, lock washers, and
nuts as shown in Figure 102: Handlebar Installation with Speaker and Control Head Mounted
Together on page 104.
MN005720A01-AB
Chapter 5: Motorcycle Radio Installation
109