Assembly Instructions

Figure 97: Exploded View of Accessory Connector Assembly (HLN6863_)

5 Squeeze the covers together bending the wires in the strain-relief features. You may need a pair

of pliers to seat the assembly covers.

6 Once the covers are fully seated, fasten them with the cover screws. Tighten the screws firmly

but do not over-tighten them. Be sure that none of the wires are pinched.

7 Reattach the accessory connector assembly to the back of the radio and fasten it by

finger-tightening the jackscrews to prevent any loosening.

NOTICE: See Enhanced Single Band Mobile Radio Basic Service Manual for detailed

descriptions of these pins and other connectors located in the mobile radio.

4.5.2

Adapter Cable

If you are planning on installing a mobile radio as a replacement for an ASTRO Spectra radio, the

following adapter cables are available:

Table 15: Adapter Cable

Part Number Description

HKN6158_ Cable, Audio Adapter Kit

HKN6159_ Cable, Data Adapter Kit

NOTICE: The adapter cables can only be connected to J2 in the rear of the transceiver.

Use the HKN6158_ audio adapter kit cable if your vehicle was formerly wired for an ASTRO Spectra or

ASTRO Spectra Plus radio, and use the rear cable pins as shown in the following figure.

MN005720A01-AB

Chapter 4: Options and Accessories Installation