Assembly Instructions

7 Reassemble the TIB following the Basic Service Manual procedure. Use 6-8 in-lbs torque on
each screw. Remember to include the TIB O-ring gasket.
8 Reattach the TIB flex.
9 Reattach the TIB to the radio transceiver.
10 To secure the TIB to the radio transceiver, apply 6-8 in-lbs of torque to each screw .
4.2.2
Horn (External Alarm) Relay Installation
Mount the horn relay in a suitable location (normally under the dash). Connect the relay contacts
across the horn ring switch, typically found in the steering column. Connect the two control wires to a
SW B+ pin and a VIP OUT pin on the VIP connector.
4.2.3
Lights (External Alarm) Relay Installation
Mount the light relay in a suitable location (normally under the dash). Connect the relay contacts
across the head lamp ON/OFF switch. Connect the two control wires to a SW B+ pin and a VIP OUT
pin on the VIP connector.
4.2.4
Gunlock Installation
The O7 or O9 control head can program up to three gunlocks through the programmable buttons.
You can set the time for the momentary trigger using the time-out trigger button. Connect the relay
contacts across the gunlock switch to install the gunlock. Connect the two control wires to a SW B+ pin
and a VIP OUT pin on the VIP connector.
Install a failsafe or redundant bypass switch for the gunlock. It is suggested to use a separate timer
switch or a manual push-on button switch to activate the gunlock. Connect the switch from the supply
to the gunlock directly, as shown in Figure 90: Gunlock Switch Redundancy Diagram on page 88.
Place the manual button at a suitable and reachable location, yet not easily seen.
MN005720A01-AB
Chapter 4: Options and Accessories Installation
87