Safety Information
Table Of Contents
- en-US
- Caution
- Compliance with RF Exposure Standards
- RF Energy Exposure Awareness and Control Information and Operational Instructions for General Population and Uncontrolled Environment Use
- RF Exposure Compliance and Control Guidelines
- Operating Instructions
- Acoustic Safety
- Mobile Antenna Installation Guidelines
- Vehicles
- Notice to Users (FCC and Industry Canada)
- Operational Warnings
- European Union (EU) Waste of Electrical and Electronic Equipment (WEEE) Directive
- ja-JP
attachments could damage the device and may result in non-compliance with RF
Safety Standards.
Vehicles
To avoid possible interference between the device transmitter and any vehicle
electronic control modules, such as ABS, engine, or transmission control modules,
your TLK 150 device should be installed only by an experienced installer, using the
following precautions when installing the device:
1
Refer to the manufacturer instructions or other technical bulletins for
recommendations on TLK 150 device installation.
2
Before installing the TLK 150 device, determine the location of the vehicle
electronic control modules and their harnesses within the vehicle.
3
Route all TLK 150 device wiring, including the antenna cable, as far away as
possible from the electronic control units and associated harnesses.
Notice to Users (FCC and Industry Canada)
This device complies with Part 15 of the FCC rules and Industry Canada's license-
exempt RSS's per the following conditions:
• This device may not cause harmful interference.
•
This device must accept any interference received, including interference that
may cause undesired operation.
• Changes or modifications made to this device, not expressly approved by
Motorola Solutions, could void the authority of the user to operate this
equipment.
Operational Warnings
The following explains the operational warnings:
For Vehicle With Air Bags
Warning:
• Refer to vehicle manufacturer’s manual prior to installation of electronic
equipment to avoid interference with air bag wiring.
•
DO NOT mount or place a mission critical device in the area over an air
bag or in the air bag deployment area. Air bags inflate with great force.
If a mission critical device is placed in the air bag deployment area and
the air bag inflates, the device may be propelled with great force and
cause serious injury to occupants of the vehicle.
English
3