User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
MN003563A01-B
Vehicle Installation
56
Send Feedback
Figure 3-7
LXN 500 Installed Inside a Trunk of a Vehicle
To install the LXN 500:
1. Connect the four brackets to the LXN 500 using the provided 4mm Allen screws. Torque the screws
to 60.7 inch-pounds (70 kg-cm).
2. Ground the LXN 500 to the vehicle chassis (See Ground Polarity on page 52).
3. Secure the LXN 500 to the mounting surface using four 1/4" self-drilling tap screws.
4. Connect the antenna cables to the connectors on the back panel of the LXN 500 (See Figure 3-1 and
Figure 3-2).
5. Connect the power cable to the PWR connector at the back panel of the LXN 500 (See Figure 3-4
and Figure 3-6).
IMPORTANT To avoid possible shout down of the LXN 500 during engine cranking, a Power Protection and
Backup unit should be used (See Installing the Optional Power Protection and Back-up Unit
on page 54).
Installing Antennas
Vehicle RF antennas must be installed in external to the vehicle and in accordance with:
•
Requirements of the antenna manufacturer/supplier.
•
Instructions provided by the installation manual of other radio devices installed next to the LXN
500.
Tray
LXN 500
Tray Lip
Mounting Brackets
Ground Connection Point
Optional Power Protection and Back-up Unit
NOTE The LXN 500 Mounting Bracket must be connected to the vehicle chassis through a low impedance
ground connection. Bolt the Mounting Bracket directly to the vehicle chassis or connect it to the vehicle
chassis by Ground wire or copper braided ground strap.
WARNING! To comply with safety regulations, the distance between antennas and people sitting inside the
vehicle must be more than 16 inches (40 cm).
When mounting antennas, the distance between antennas must be more than 16 inches (40 cm).