User's Manual

55
MN003563A01-B
Vehicle Installation
Send Feedback
The NAV-PAC has two available models: NP-12 NAV-PAC for 12 Volt vehicle and NP-24 NAV-PAC for 24
Volts vehicles.
Figure 3-6 Installing the Optional Power Protection and Back-up Unit
For detailed information on the LXN 500 installation, refer to the NAV-PAC INSTALLATION AND
OPERATION MANUAL provided with the NAV-PAC.
Installing the LXN 500
The LXN 500 should be mounted inside the vehicle so that cables coming from all peripheral devices
can be connected easily to the connectors on the back panel. The LXN 500 is designed to be mounted
on a flat surface in any position as long as the rear and front panels are accessible.
The LXN 500 is mounted by four mounting brackets (See Figure 3-7 and Figure 3-4). The mounting
brackets of the LXN 500 enable to mount the LXN 500 on a flat horizontal or vertical surface. The unit is
usually installed inside a trunk of a vehicle, or on tray or any fixed mounting board (See Figure 3-7).
IMPORTANT To prevent overheat damage to the LXN 500, the unit is designed to automatically shut down
above 60°C (149°F).
PWR
INPUT
OUTPUT
+ -+ -
+ -+ -
IMPORTANT Connect the red wire directly to the (+) terminal of the vehicle battery and the black wire to the chassis
of the vehicle.
20A Fuse
CAUTION When installed inside a vehicle trunk, be aware that ventilation of the trunk may be
necessary to keep the LXN 500 within ambient temperature limits of -4°F to 140°F (-20°C
to +60°C). If necessary, add fans to control the ambient temperature inside the trunk.