User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
51
MN003563A01-B
Vehicle Installation
Send Feedback
•
Liquid Propane (LP) gas warning
•
Usability by driver/operator
•
Vehicle vendor instructions
•
Local vehicle authority regulations/design rules
•
LXN 500 Mounting Location
Correct positioning of the components will ensure that the LXN 500 system meets the following
requirements:
•
The LXN 500 is installed inside a ventilated compartment or inside a trunk. To cool the LXN 500,
allow suf
ficient space around the LXN 500 for free air flow (See Figure 3-3).
•
It will not injure the operator or passenger in case of an accident.
•
It does not interfere with the driver’s vision or hinder the driver when driving the vehicle.
•
Place the LXN 500 so that it can be easily removed for servicing.
•
Do not mount the LXN 500 system units and route cables where they can be kicked by the driver’s
or other passenger’s
feet.
•
Verify that the mounting surface is able to support the weight of the units.
•
Select a location that permits routing the RF antenna cables as directly as possible.
•
Do not mount units on a flat or concave surface where the unit could become partially submersed
in water
.
.
Ventilation
The LXN 500 is designed to operate properly in an ambient temperature range of –20°C to 60°C (-4°F to
149°F). The LXN 500 must be installed in an unobstructed location to allow proper air flow and away
from heat generating equipment such as: radio transmitters, power amplifiers or a cabin heater (See
Figure 3-3).
CAUTION When installing the LXN 500, make sure that the LXN 500 is tightly anchored to the
vehicle structure. Unstable mounts can damage the unit.
CAUTION
•
To avoid overheating of the LXN 500, do not place any object on the LXN 500.
•
To prevent overheat damage to the LXN 500, the unit is designed to automatically shut
down at 60°C (149°F)