User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
MN003563A01-B
Vehicle Installation
50
Send Feedback
Preparing to Install the LXN 500
Tools
The following tools and service aids are recommended for installation:
•
Set of Phillips and flat head screwdriver bits
•
T-6 through T-25 torx bits
•
Battery / air operated drill
•
Set of high speed drill bits (including 6mm bit for bracket holes)
•
Ratchet with extensions
•
Socket torque wrench
•
Socket set (Metric & Imperial)
•
Wrenches (Metric & Imperial)
•
Utility knife
•
Wire cutter
•
Volt-Ampere-Ohm meter
•
Automotive test light
•
Wire Crimp Tool
•
CAT-5e cable tester
•
Measuring tape
•
Flashlight
Materials
The hardware required to install the LXN 500 in a vehicle consists of:
•
Tie wraps
•
Electrical tape
•
Wire taps
•
Rubber grommets
•
Spare wire (8-22 gauge)
•
Variety of self tapping screws and bolts
•
Wire connectors / wire terminals / wire lugs / eyelets
Planning
Be sure to consider the following issues when planning the installation:
•
Installation location away from air bag deployment zones
•
Environmental considerations
•
Electrical guidelines