User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
49
MN003563A01-B
Vehicle Installation
Send Feedback
Dual Diversity Antenna Configuration
The dual diversity antenna is a layout of two diversity antennas connected in MIMO (Multiple Input,
Multiple Output) configuration.
Each antenna is provided with three short, flexible 12-ft coaxial cables (threads) coming out of the
antenna bottom side.
In one antenna, the cables are connected to the LTE1 and GPS ports of the LXN 500. In the second
antenna, the cables are connected to the LTE2 and WIFI ports of the LXN 500.
Figure 3-2
Dual Diversity Antenna
Battery
LXN500
on trunk floor
At least 8” (20 cm)
Important: Orient antenna as shown
PWR
LTE1
LTE2
GPS
WIFI
LTE Ant
GPS Ant
EVDO Ant
LTE Ant
At least 16” (40 cm)
Keep at least 16 inch (40 cm) between antennas